Filter
Top Products
224 CHAPTER 8: MOBILITY DOMAIN COMMANDS
clear
mobility-domain
Clears all Mobility Domain configuration and information from a WX
switch, regardless of whether the WX switch is a seed or a member of a
Mobility Domain.
Syntax —
clear mobility-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX switch is not configured
as part of a Mobility Domain.
Examples — To clear a Mobility Domain from a WX switch within the
domain, type the following command:
WX1200# clear mobility-domain
success: change accepted.
See Also
clear mobility-domain member on page 224
set mobility-domain member on page 227
set mobility-domain mode member seed-ip on page 227
set mobility-domain mode seed domain-name on page 228
clear
mobility-domain
member
On the seed WX switch, removes the identified member from the
Mobility Domain.
Syntax —
clear mobility-domain member ip-addr
ip-addr — IP address of the Mobility Domain member, in dotted
decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.