Filter
Top Products
264 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set service-profile wep active-multicast- index on page 315
set service-profile wep active-unicast- index on page 316
set service-profile wep key-index on page 317
set service-profile wpa-ie on page 318
reset {ap | dap} Restarts an MAP access point.
Syntax —
reset {ap port-list | dap dap-num}
ap port-list — List of ports connected to the MAP access points to
restart.
dap dap-num — Number of a Distributed MAP to reset.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — When you enter this command, the MAP access point drops all
sessions and reboots.
CAUTION: Restarting an MAP access point can cause data loss for users
who are currently associated with the MAP.
Examples — The following command resets the MAP access point on
port 6:
WX1200# reset ap 6
This will reset specified AP devices.
Would you like to continue? (y/n)y
success: rebooting ap attached to port 6
set {ap | dap} bias Changes the bias for a MAP. Bias is the priority of one WX switch over
other WX switches for booting and configuring the MAP.
Syntax —
set {ap port-list | dap dap-num} bias {high | low}
ap port-list — List of ports on which to change the bias for directly
connected MAPs.