Filter
Top Products
set radio-profile beacon-interval 287
set radio-profile
beacon-interval
Changes the rate at which each MAP radio in a radio profile advertises its
service set identifier (SSID).
Syntax —
set radio-profile name beacon-interval interval
name — Radio profile name.
interval — Number of milliseconds (ms) between beacons. You can
specify from 25 ms to 8191 ms.
Defaults — The beacon interval for MAP radios is 100 ms by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Examples — The following command changes the beacon interval for
radio profile rp1 to 200 ms:
WX4400# set radio-profile rp1 beacon-interval 200
success: change accepted.
See Also
display radio-profile on page 257
set radio-profile mode on page 291
set radio-profile
dtim-interval
Changes the number of times after every beacon that each MAP radio in
a radio profile sends a delivery traffic indication map (DTIM). An MAP
access point sends the multicast and broadcast frames stored in its
buffers to clients who request them in response to the DTIM.
The DTIM interval applies to both the beaconed SSID and the
nonbeaconed SSID.
Syntax —
set radio-profile name dtim-interval interval
name — Radio profile name.
interval — Number of times the DTIM is transmitted after every
beacon. You can enter a value from 1 through 31.