Filter
Top Products
104 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
Example
To establish a mapping between IP address 129.102.0.1 and MAC address
00e0-fc01-0000, and to send frames to this address through VLAN 1, Ethernet
port 1/0/1, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]arp static 202.38.0.10 00e0-fc01-0000 1 arp timer aging
Syntax
arp timer aging aging_time
undo arp timer aging
View
System View
Parameter
aging_time Enter the aging time of dynamic ARP aging timer, in the range 1 to
1440 minutes. The default is 20 minutes.
Description
Use the arp timer aging command to configure the dynamic ARP aging timer.
Use the undo arp timer aging command to restore the default time of 20
minutes.
Related commands: display arp timer aging
Example
To configure the dynamic ARP aging timer to 10 minutes, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]arp timer aging 10
debugging arp packet Syntax
debugging arp [ packet | error | info packet ]
undo debugging arp packet
View
User View
Parameters
error Enter to enable ARP error debugging.
info Enter to enable ARP mapping table and information management
debugging.
packet Enter to enable ARP packet debugging.