Filter
Top Products
114 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
The information shown above indicates that vlan-interface 2 is configured with a
DHCP Server group whose ID is 0.
Access Management
Configuration
Commands
This section describes the commands you can use to configure and manage the
Access Management Configuration operations on your Switch 4500.
am enable Syntax
am enable
undo am enable
View
System View
Parameter
none
Description
Use the am enable command to enable the access management function.
Use the undo am enable command to disable the function.
By default, the Access management function is disabled.
When using the access management function, It is recommended that you cancel
the static ARP configuration to ensure that the binding of the IP address and
Ethernet switch takes effect. If you have configured the static ARP for an IP
address in the current port IP address pool from another port, the system will
prompt you to cancel the static ARP setting.
Example
To enable the access management function, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]am enable
am ip-pool Syntax
am ip-pool address-list
undo am ip-pool { all | address-list }
View
Ethernet Port View
Parameters
all Enter to configure to operate on all the IP addresses (or IP address pools).
ip-pool Enter to configure IP address pool for access management.