Filter
Top Products
AAA and RADIUS Configuration Commands 261
For a Switch, each supplicant belongs to an ISP domain. The system supports up to
16 ISP domains. If a user has not reported its ISP domain name, the system will
put it into the default domain.
When this command is used, if the specified ISP domain does not exist, the system
will create a new ISP domain. All the ISP domains are in the
active state when
they are created.
Related commands: access-limit, radius scheme, state, display domain.
Example
To create a new ISP domain, marlboro.net, and enters its view, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]domain marlboro.net
New Domain added.
[4500-isp-marlboro.net]
idle-cut Syntax
idle-cut { disable | enable minute flow }
View
ISP Domain View
Parameter
disable: means disabling the user to use idle-cut function .
enable: means enabling the user to use the function.
minute: Specifies the maximum idle time, ranging from 1 to 120 and measured in
minutes.
flow: The minimum data traffic, ranging from 1 to 10,240,000 and measured in
bytes.
Description
Use the idle-cut command to configure the user template in the current ISP
domain.
By default, after an ISP domain is created, this attribute in user template is
disable, that is, the user idle-cut is disabled.
The user template is a set of default user attributes. If a user requesting for the
network service does not have some required attributes, the corresponding
attributes in the template will be endeavored to him as default ones. The user
template of the Switch you are using may only provide user idle-cut settings. After
a user is authenticated, if the idle-cut is configured to enable or disable by neither
the user nor the RADIUS server, the user will adopt the idle-cut state in the
template.
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.