Filter
Top Products
244 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Related commands: display dot1x.
Example
To configure the current device to transmit an authentication request frame to the
user for no more than 9 times, enter the following:
<4500>system-view
System View: return to User View with Ctrl-Z
[4500]dot1x retry 9
dot1x supp-proxy-check Syntax
dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
undo dot1x supp-proxy-check { logoff | trap } [ interface
interface-list ]
View
Ethernet Port View
Parameter
logoff: Cuts network connection to a user upon detecting the use of proxy.
trap: Sends a trap message upon detecting a user using proxy to access the
Switch.
interface interface-list: Ethernet interface list including several Ethernet
interfaces, expressed in the format
interface-list = { interface-num [ to
interface-num ] } & < 1-10 >
. interface-num specifies a single Ethernet
interface in the format
interface-num = { interface-type interface-num |
interface-name }
, where interface-type specifies the interface type,
interface-num specifies the interface number and interface-name specifies the
interface name. For the respective meanings and value ranges, see the parameters
in the Port Command chapter.
Description
Use the dot1x supp-proxy-check command to configure the control method for
802.1x proxy users on the specified interface. Use the
undo dot1x
supp-proxy-check
command to cancel the control method set for 802.1x proxy
users.
Note that when performing this function, the user logging on via proxy needs to
run the 3Com 802.1x client program, (3Com 802.1x client program version V1.29
or above is needed).
This command is used to set a control method on the specified interface when
executed in System View. The parameter interface-list cannot be input when the
command is executed in Ethernet Port View and it takes effect only on the current
interface. After globally enabling proxy user detection and control in System View,
only if you enable this feature on a specific port can this configuration take effect
on the port.
Related command: display dot1x.