Filter
Top Products
262 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Related command: domain
Example
To enable the user in the current ISP domain, 3Com163.net, to use the idle-cut
attribute specified in the user template (that is, enabling the user to use the
idle-cut function). The maximum idle time is 50 minutes and the minimum data
traffic is 500 bytes.
<4500> system-view
System View: return to User View with Ctrl+Z.
[4500]domain marlboro.net
[4500-isp-marlboro.net]idle-cut enable 50 500
level Syntax
level level
undo level
View
Local User View
Parameter
level: Specifies user priority level, an integer ranging from 0 to 3.
Description
Use the level command to configure user priority level. Use the undo level
command to restore the default user priority level.
By default, the user priority level is 0.
Related command: local-user
If the configured authentication mode is none authentication or password
authentication, the command level that a user can access after login depends on
the priority of user interface. In the case of authentication requiring both
username and password, however, the accessible command level depends on user
priority level.
Example
To set the priority level of the user 3Com to 3, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]local-user 3Com1
[4500-luser-3Com1]level 3
local-user Syntax
local-user user-name
undo local-user { user-name | all [ service-type { telnet | ftp |
lan-access | ssh | terminal } ] }