Filter
Top Products
RIP Configuration Commands 161
View
Interface View
Parameter
None
Description
Use the rip output command to allow an interface to transmit RIP packets.
Use the undo rip output command to disable an interface from transmitting RIP
packets.
By default, all interfaces except loopback interfaces are able to transmit RIP
packets.
This command is used in conjunction with two other commands: rip input and
rip work. rip input and rip output control, respectively, the receipt and the
transmission of RIP packets on an interface.
rip work allows both receipt and
transmission of RIP packets.
Related commands; rip input, rip work.
Example
To prevent the interface Vlan-interface 1 from transmitting RIP packets, enter the
following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Vlan-interface 1
[4500-Vlan-interface1]undo rip output
rip split-horizon Syntax
rip split-horizon
undo rip split-horizon
View
Interface View
Parameter
None
Description
Use the rip split-horizon command to configure an interface to use split
horizon when transmitting RIP packets. This is the default.
Use the undo rip split-horizon command to configure an interface not to use
split horizon when transmitting RIP packets.
Normally, split horizon is necessary for preventing router loops. You may need to
disable split horizon to ensure proper operation of protocols.