Filter
Top Products
352 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
after the synchronization information statistics and detection, you must execute
the
undo info-center switch-on command to disable the switch in time.
For the related commands, see display debugging.
Example
Enable IP Packet debugging.
<SW4500>debugging ip packet
IP packet debugging switch is on.
display
diagnostic-information
Syntax
display diagnostic-information
View
All views
Parameter
None
Description
Use the display diagnostic-information command to view the configuration
information on all currently running modules. This information helps you to
monitor and troubleshoot your Switch 4500.
Example
To display system information on all currently running modules, enter the
following:
<SW4500>display diagnostic-information
Network Connection
Test Commands
This section describes the network connection test commands available on your
Switch 4500.
end-station polling
ip-address
Syntax
end-station polling ip-address ip-address
undo end-station polling ip-address ip-address
View
System view
Parameter
ip-address: Specify the IP address.
Description
Use the end-station polling ip-address command to configure the IP address
requiring periodic testing.