Filter
Top Products
162 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
Example
To set the interface Vlan-interface 1 not to use split horizon when processing RIP
packets, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Vlan-interface 1
[4500-Vlan-interface1]undo rip split-horizon
rip version Syntax
rip version 1
rip version 2 [ broadcast | multicast ]
undo rip version
View
Interface View
Parameters
1 Enter to set the interface version to RIP-1.
2 Enter to set the interface version to RIP-2.
broadcast Enter to set the transmission mode of a RIP-2 packet to broadcast.
multicast Enter to set the transmission mode of a RIP-2 packet to multicast.
Description
Use the rip version command to configure the version number of RIP packets
on an interface.
Use the undo rip version command to restore the default RIP packet version on
the interface. The interface RIP version is RIP-1.
By default, RIP-1 transmits packets in broadcast mode, while RIP-2 transmits
packets in multicast mode.
When running RIP-1, the interface receives and transmits RIP-1 packets, and can
also receive RIP-2 broadcast packets.
When running RIP-2 in broadcast mode, the interface receives and transmits RIP-2
broadcast packets, and can also receive both RIP-1 packets and RIP-2 multicast
packets.
When running RIP-2 in multicast mode, the interface receives and transmits RIP-2
multicast packets, and can also receive RIP-2 broadcast packets. The interface can
not receive RIP-1 packets.
Example
To configure the interface Vlan-interface 1 to RIP-2 broadcast mode, enter the
following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Vlan-interface 1