Filter
Top Products
RADIUS Protocol Configuration Commands 289
Related commands: radius scheme, retry.
Example
To set the response timeout timer of RADIUS scheme, 3Com, to 5 seconds, enter
the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]radius scheme 3Com
[4500-radius-3Com]timer 5
timer quiet Syntax
time quiet minutes
undo timer quiet
View
RADIUS Scheme View
Parameter
minutes: Quiet time interval, ranging from 1 to 255 in minutes. The default value
is 5.
Description
Use the timer quiet command to set the quiet time interval after which the
primary and secondary RADIUS scheme servers switch over. Use the
undo timer
quiet
to set the quiet time interval to its default value.
The functions of the quite time interval are as follows:
1 The Switch sends RADIUS packets to the primary RADIUS server.
2 If the Switch affirms that the primary server does not respond, it then sends
RADIUS packets to the secondary RADIUS server.
3 After each quiet time interval, the Switch sets the status of the primary RADIUS
server to active and sends RADIUS packets to it next time.
Example
To set the quiet time interval of the RADIUS server group ‘3Com’ to 3 minutes,
enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z
[4500]radius scheme 3com
[4500-radius-3com]timer quiet 3
timer
realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
RADIUS Scheme View