Filter
Top Products
166 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
IP Routing Policy
Configuration
Commands
This section describes the commands you can use to configure IP Routing Policy.
These commands operate across all routing protocols.
When the Switch 4500 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router or to
the Switch 4500 running a routing protocol.
apply cost Syntax
apply cost value
undo apply cost
View
Route Policy View
Parameter
value Enter the route cost value of route information.
Description
Use the apply cost command to configure the route cost value of route
information. This command is one of the
apply sub-statements of the
Route-policy attribute set.
Use the undo apply cost command to cancel the apply sub-statement.
Related commands: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, and route-policy.
Example
Define one apply sub-statement. When it is used for setting route information
attribute, it sets the route metric value of route information to 120.
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]route-policy permit node 1
% New sequence of this list
[4500-route-policy]apply cost 120
display ip ip-prefix Syntax
display ip ip-prefix [ ip_prefix_name ]
View
All views
Parameter
ip_prefix_name Enter displayed address prefix list name.
Description
Use the display ip ip-prefix command to view the address prefix list.
Related command: ip ip-prefix.