Filter
Top Products
Installing the Module 3-9
6 Close the 24-Port module ejectors as shown in Figure 3-3.
Figure 3-3 Open and Closed Module Ejectors
7 Fasten the spring-loaded screws on the front of the 24-Port module
faceplate to the hub using your fingers (do not overtighten).
8 Attach 180° 50-pin cable connectors to the 50-pin connectors on the
front of the module (see Figure 3-4), using the small screws included in
the shipping carton. If you're using 90° connectors, refer to the section
Using 90° Cable Connectors
later in this chapter.
Open
ejector
Closed
ejector