Filter
Top Products
LLDP Commands
4-201
4
Example
lldp basic-tlv management-ip-address
This command configures an LLDP-enabled port to advertise the management
address for this device. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv management-ip-address
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The management address protocol packet includes the IPv4 address of the
switch. If no management address is available, the address should be the
MAC address for the CPU or for the port sending this advertisement.
• The management address TLV may also include information about the
specific interface associated with this address, and an object identifier
indicating the type of hardware component or protocol entity associated with
this address. The interface number and OID are included to assist SNMP
applications to perform network discovery by indicating enterprise specific or
other starting points for the search, such as the Interface or Entity MIB.
• Since there are typically a number of different addresses associated with a
Layer 3 device, an individual LLDP PDU may contain more than one
management address TLV.
• Every management address TLV that reports an address that is accessible on
a port and protocol VLAN through the particular port should be accompanied
by a port and protocol VLAN TLV that indicates the VLAN identifier (VID)
associated with the management address reported by this TLV.
Example
lldp basic-tlv port-description
This command configures an LLDP-enabled port to advertise its port description.
Use the no form to disable this feature.
Console(config)#interface ethernet 1/1
Console(config-if)#lldp mednotification
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#