Filter
Top Products
Command Line Interface
4-324
4
show ip dhcp snooping binding
This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
IP Cluster Commands
IP Clustering is a method of grouping switches together to enable centralized
management through a single unit. A switch cluster has a “Commander” unit that is
used to manage all other “Member” switches in the cluster. The management station
uses Telnet to communicate directly with the Commander throught its IP address,
and the Commander manages Member switches using cluster “internal” IP
addresses. There can be up to 36 Member switches in one cluster. Cluster switches
are limited to within a single IP subnet.
cluster
This command enables clustering on the switch. Use the no form to disable
clustering.
Syntax
[no] cluster
Default Setting
Enabled
Command Mode
Global Configuration
Console#show ip dhcp snooping binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
----------------- --------------- ---------- -------------------- ---- ---------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
Table 4-86 Switch Cluster Commands
Command Function Mode Page
cluster Configures clustering on the switch GC 4-324
cluster commander Configures the switch as a cluster Commander GC 4-325
cluster ip-pool Sets the cluster IP address pool for Members GC 4-326
cluster member Sets Candidate switches as cluster members GC 4-326
rcommand Provides configuration access to Member switches GC 4-327
show cluster Displays the switch clustering status PE 4-327
show cluster members Displays current cluster Members PE 4-328
show cluster candidates Displays current cluster Candidates in the network PE 4-328