Filter
Top Products
Command Line Interface
4-280
4
Example
show policy-map interface
This command displays the service policy assigned to the specified interface.
Syntax
show policy-map interface
interface
input
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
Command Mode
Privileged Exec
Example
Voice VLAN Commands
The switch allows you to specify a Voice VLAN for the network and set a CoS priority
for the VoIP traffic. VoIP traffic can be detected on switch ports by using the source
MAC address of packets, or by using LLDP (IEEE 802.1AB) to discover connected
VoIP devices. When VoIP traffic is detected on a configured port, the switch
automatically assigns the port to the Voice VLAN. Alternatively, switch ports can be
manually configured.
Console#show policy-map
Policy Map rd_policy
class rd_class
set ip dscp 3
Console#show policy-map rd_policy class rd_class
Policy Map rd_policy
class rd_class
set ip dscp 3
Console#
Console#show policy-map interface ethernet 1/5
Service-policy rd_policy input
Console#
Table 4-73 Voice VLAN Commands
Command Function Mode Page
voice vlan Defines the Voice VLAN ID GC 4-281
voice vlan aging Configures the aging time for Voice VLAN ports GC 4-282
voice vlan mac-address Configures VoIP device MAC adresses GC 4-282
switchport voice vlan Sets the Voice VLAN port mode IC 4-283
switchport voice vlan rule Sets the automatic VoIP traffic detection method for ports IC 4-284