Filter
Top Products
Multicast Filtering Commands
4-287
4
Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query for any
attached hosts that want to receive a specific multicast service. It identifies the ports
containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to
ensure that it will continue to receive the multicast service.
IGMP Snooping Commands
This section describes commands used to configure IGMP snooping on the switch.
Table 4-74 Multicast Filtering Commands
Command Groups Function Page
IGMP Snooping Configures multicast groups via IGMP snooping or static
assignment, sets the IGMP version, displays current snooping and
query settings, and displays the multicast service and group
members
4-287
IGMP Query Configures IGMP query parameters for multicast filtering at Layer 2 4-292
Static Multicast Routing Configures static multicast router ports 4-295
IGMP Filtering and Throttling Configures IGMP filtering and throttling 4-297
Multicast VLAN Registration Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving
security and data isolation for normal traffic
4-304
Table 4-75 IGMP Snooping Commands
Command Function Mode Page
ip igmp snooping Enables IGMP snooping GC 4-288
ip igmp snooping vlan static Adds an interface as a member of a multicast group GC 4-288
ip igmp snooping version Configures the IGMP version for snooping GC 4-289
ip igmp snooping
leave-proxy
Enables IGMP leave proxy on the switch GC 4-289
ip igmp snooping
immediate-leave
Enables IGMP immediate leave for a VLAN interface IC 4-290
show ip igmp snooping Shows the IGMP snooping and query configuration PE 4-289
show mac-address-table
multicast
Shows the IGMP snooping MAC multicast list PE 4-291