Filter
Top Products
6 Troubleshooting
152
System Boots when Installing PCI Card
System Server Management features require full-time “standby”
power. This means some parts of the system have power going to
them whenever the power cord is plugged in, even if you have turned
the system power off with the power button on the front panel. If you
install a PCI card with the AC power cord plugged in, a signal may be
sent to command the system to boot. Before installing a PCI card, you
should always:
• Turn off the server power by using the power button on the front of the
system.
• Unplug the AC power cord(s) from the server.
Problems with Newly Installed Application Software
Problems that occur when you run new application software are
usually related to the software, not the server hardware. Faulty
equipment is unlikely, especially if other software runs correctly.
Check the following:
• Make sure the system meets the minimum hardware requirements for the
software. See the software documentation.
• Make sure the software is properly installed and configured for the system.
See the software documentation.
• Use only an authorized copy. Unauthorized copies often do not work.
• If you are running the software from a floppy disk, CD-ROM or DVD/CD-
RW, try a different disk.
• Make sure the correct device drivers installed.
• If the problems persist, contact the software vendor’s customer service
representative.
Problems with Application Software that Ran
Correctly Earlier
Problems that occur after the system hardware and software have
been running correctly sometimes indicate equipment failure.
However, they can also be caused by file corruption or changes to the
software configuration.
Check the following:
• If you are running the software from a floppy disk, CD-ROM or DVD/CD-
RW, try a different disk.