Filter
Top Products
4 Configuring the system
72
Installing and Removing a PCI Riser
Connector
CAUTION: PCI riser connectors are NOT hot swappable. Before
removing or replacing the riser connector, you must first take the
server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and
unplug the AC power cord from the system or wall outlet.
Installing a PCI Riser Connector
To install the PCI riser connector, use the following instructions.
1 Observe the safety and ESD precautions at the beginning of this
book. See “Safety Information.”
2 Power down the server and unplug all peripheral devices and the
AC power cable.
3 Remove the chassis cover. For instructions, see “Removing the
Chassis Cover.”
4 Pull up on the two latches on the assembly. See letter “A” in the
figure below.
5 Lift the PCI riser assembly from the chassis.