Filter
Top Products
57
9 Push down on the connector cover to lock the cable into place. See
letter “C” in the figure below.
10 Open the connector on the interposer board by pulling out on the
connector cover. See letter “D” in the figure below.
11 Insert the loose end of the floppy cable into the interpose board
connector. See letter “E” in the figure below.
12 Push in on the connector cover to lock the cable into place. See
letter “F” in the figure below.
13 Lower the interposer board into the floppy drive tray at the rear of
the floppy drive and engage the notch on the board. See Letter
“A” in the figure below.
14 Attach the interposer board to floppy drive with the screw that
was included with the interposer board. See letter “B” in the
figure below. In the diagram, the flat flex cable been removed for
clarity.