Filter
Top Products
4 Configuring the system
54
10 Slide the floppy drive assembly into the slimeline bay of the chassis
until it clicks into place. See letter “A” in the figure below.
11 Open the connector labeled “Floppy Con” on the backplane by
pulling up on the connector cover. See letter “B” in the figure
below.
12 Insert the loose end of the floppy cable into the backplane
connector. See letter “C” in the figure below.
13 Push in on the connector cover to lock the cable into place. See
letter “D” in the figure below.
14 Install the chassis cover. For instructions, see “Installing the Chassis
Cover.”
15 (Optional) Install the front bezel. For instructions, see “Removing
and Installing the Front Bezel.”
16 Plug all peripheral devices and the AC power cable back into the
server.