Filter
Top Products
47
1 Observe the safety and ESD precautions at the beginning of this
book. See “Safety Information.”
2 Power down the server and unplug all peripheral devices and the
AC power cable.
3 Remove the chassis cover. For instructions, see “Removing the
Chassis Cover.”
4 Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
5 Disconnect the SATA data connector and power cables from the
rear of the SATA drive.
6 Press the latch on the back of the fixed drive carrier and slide it out
of the bay.
7 Remove the four screws that attach the hard drive to the drive
carrier. Lift the drive from the carrier. Store the drive in an anti-
static bag.
8 If you are not installing a new drive, place the plastic retention
device into the drive carrier, using the four screws you removed
from the hard drive.
9 Insert the screws that held the drive in the carrier into the screw
locations on the carrier for future use.
10 Slide the drive carrier back into the chassis until it clicks into place.
NOTE:For proper airflow, the hard drive carrier must be replaced
in the chassis, even if no hard drive is installed in it.
11 (Optional) Install the front bezel. For instructions, see “Removing
and Installing the Front Bezel.”
12 Install the chassis cover. For instructions, see “Removing the
Chassis Cover.”
13 Plug all peripheral devices and the AC power cable back into the
server.