Filter
Top Products
10
Remote user (via X100/X200 extender)
Up to four users can be placed a
maximum of 300 metres (980 feet)
from the AdderView CATx unit.
Remote users are connected via
an Adder X100 or X200 extender
module and suitable category 5,
5e or 6 cabling (with no crossover).
The AdderView CATx IP models
provide two remote user ports.
Cable lengths for remote user locations
The maximum length of cable between a remote user and the AdderView CATx
unit can be up to 300 metres (980 feet). However, bear in mind that the overall
distance between any remote user and any computer system must not exceed
300 metres (980 feet).
In situations where any computer system will be placed a significant distance
from the AdderView CATx unit, ensure that the distance to any remote user is
similarly less than 300 metres (980 feet).
To connect a remote user
1 Place an Adder X100 or X200 extender unit adjacent to the remote user
location.
2 Attach the video monitor,
keyboard, mouse, power adapter
(and speaker) connectors to the
sockets of the Adder
X100 or X200
module.
3 Lay a suitable length of category 5, 5e or 6 cabling between the Adder
X100/X200 module and the AdderView CATx unit. Please refer to the
section
Cable lengths for remote user locations opposite.
4 Attach the connector of the cable run to the socket of the Adder X100/X200.
5 At the other end of the cable run, attach the cable connector to one of the
sockets labelled
CATx USER PORTS on the rear panel of the AdderView CATx
unit.
From mouse
From keyboard
From video monitor
From power adapter
Category 5, 5e or
6 cable leading to
AdderView CATx unit
Category 5, 5e or 6 cable
from Adder X100/X200
module
6 Where necessary, use the in-built video compensation feature of the Adder
X100/X200 module to eliminate any effects caused by the cable run.
However, ensure that the links between the computers and the AdderView
CATx have been compensated first. See remote user video compensation
for details.
Adder X100/X200
module
Adder X100/X200
module
AdderView CATx
rear panel
Note: The AdderView
CATx model shown here
is a non-IP version. The
IP-version provides only
remote user ports 3
and 4.