Filter
Top Products
42
Placing AdderView CATx IP behind a router or firewall
A possible point of contention between the AdderView CATx IP and a firewall
can occasionally arise over the use of IP ports. Every port through the firewall
represents a potential point of attack from outside and so it is advisable to
minimise the number of open ports. The AdderView CATx IP usually uses two
separate port numbers, however, these are easily changeable and can even be
combined into a single port.
IMPORTANT: The correct configuration of routers and firewalls requires
advanced networking skills and intimate knowledge of the particular network.
Adder Technology cannot provide specific advice on how to configure your
network devices and strongly recommend that such tasks are carried out by a
qualified professional.
Port settings
As standard, the AdderView CATx IP uses two ports to support its two types of
viewer:
• Port 80 for users making contact with a web browser, and
• Port 5900 for those using the VNC viewer.
When these port numbers are used, VNC viewers and web browsers will locate
the AdderView CATx IP correctly using only its network address. The firewall/
router must be informed to transfer any traffic requesting these port numbers
through to the AdderView CATx IP.
When a web server is also on the local network
Port 80 is the standard port used by web (HTTP) servers. If the AdderView CATx
IP is situated within a local network that also includes a web server or any other
device serving port 80 then, if you want to use the web browser interface from
outside the local network environment, the HTTP port number of the AdderView
CATx IP may need to be changed.
When you change the HTTP port to anything other than 80, then each remote
browser user will need to specify the port address as well as the IP address. For
instance, if you set the HTTP port to ‘8000’ and the IP address is ‘192.168.47.10’
then browser users will need to enter:
http://192.168.47.10:8000
(Note the single colon that separates the IP address and the port number).
The firewall/router would also need to be informed to transfer all traffic to the
new port number through to the AdderView CATx IP.
If you need to change the VNC port number
If you change the VNC port to anything other than 5900, then each VNC viewer
user will need to specify the port address as well as the IP address. For instance,
if you set the VNC port to ‘11590’ and the IP address is ‘192.168.47.10’ then
VNC viewer users will need to enter:
192.168.47.10::11590
(Note the double colons that separate the IP address and port number).
The firewall/router would also need to be informed to transfer all traffic to the
new port number through to the AdderView CATx IP.
Addressing
When the AdderView CATx IP is situated within the local network, you will need
to give it an appropriate local IP address, IP network mask and default gateway.
This is achieved most easily using the DHCP server option which will apply
these details automatically. If a DHCP server is not available on the network,
then these details need to be applied manually in accordance with the network
administrator.
The firewall/router must then be informed to route incoming requests to port
5900 or port 80 (if available) through to the local address being used by the
AdderView CATx IP.
AdderView CATx IP has a local
address and net mask, i.e.
IP address: 192.168.0.3
Net mask: 255.255.255.0
Remote user with VNC viewer
accesses IP address: 129.7.1.10
and automatically uses port
5900.
Firewall/router address:
129.7.1.10
The firewall routes the
request from the VNC viewer
on port 5900 through to the
AdderView CATx IP at local
address 192.168.0.3