Filter
Top Products
77
USB Country Code
Some computers query the keyboard to find
out its country code and key layout. These
computers use this information to configure
the way that they interpret the data coming
from the keyboard and so it is important for
the correct country information to be supplied.
Not all keyboards report country information
and two different styles of keyboard may be
connected to the AdderView CATx.
Country Code
Settings: AUTO, MANUAL, DISABLED
In AUTO mode the AdderView CATx will at-
tempt to query the keyboard attached to the
local port to ascertain a country code. If a country code is not found then the
AdderView CATx will use the current value of the Default Country option. In
MANUAL mode, the connected local keyboard is not queried for country infor-
mation and instead the Default Country value is reported to all computers that
request country information. In DISABLED mode, no country information is sup-
plied to computers requesting country information.
Default Country
The codes that may be used within this option are as follows:
Country Code Country Code
Arabic 01 Persian (Farsi) 20
Belgian 02 Poland 21
Canadian-Bilingual 03 Portugese 22
Canadian-French 04 Russian 23
Czech Republic 05 Slovakian 24
Danish 06 Spanish 25
Finnish 07 Swedish 26
French 08 Swiss/French 27
German 09 Swiss/German 28
Greek 10 Switzerland 29
Hebrew 11 Taiwan 30
Hungary 12 Turkish-Q 31
International (ISO) 13 UK 32
Italian 14 US 33
Japan (Katakana) 15 Yugoslavia 34
Korean 16 Turkish-F 35
Latin American 17 Reserved 36-255
Netherlands 18 Not supported 00
Norwegian 19
ADDERVIEW CATx IP
USB Country Code
Country Code AUTO
Default Country 32
Space-Toggle
-Up -Down Esc-Quit
Setup Options 2
Force Mode
Settings: DISABLED, ENABLED
Available only on non-IP CATx units. Force Mode allows an ADMIN user on port
1 to select which computers the other user ports should be switched to. When
enabled, the ADMIN user (on port 1) can press the TAB key to show what user 2
is currently viewing. The ADMIN user can then select an alternative computer for
user 2. Once set, the ADMIN user can press the TAB key again to move to the
next user port and so on.
Alternatively, the ADMIN user (on port 1) can press CTRL and either 1, 2, 3 or 4
to show the current video display on any port.
To end Force mode, the ADMIN user can, either:
• Press the ESC key
• Press TAB until user 1 is shown
• Press CTRL +1