Filter
Top Products
81
Modem Configuration
This page allows you to configure the COM1 serial port located at the rear of
the AdderView CATx IP.
Server IP / Client IP
When a user dials into the AdderView CATx IP via a modem or ISDN adapter, the
AdderView CATx IP sets up a temporary two-device network using PPP (Point to
Point Protocol). For this purpose, both devices must have ‘dummy’ IP addresses
so that they can communicate correctly. These two addresses can be almost
anything expressed in the quad octet format (i.e. 192.168.3.1.). However, it is
advisable not to make them the same as the real IP addresses used by either the
remote system or the AdderView CATx.
Baud Rate
This option configures the speed of the serial connection between the
AdderView CATx IP and a connected modem or ISDN terminal adapter. The
default setting is 115200. The other communication settings are fixed as: No
parity, 8 bit word, 1 stop bit.
Init String
The codes entered here are used to prepare the connected modem or ISDN
terminal adapter for use with the AdderView CATx IP. The default code is
a Hayes-compatible string to configure auto answer mode and would be
understood by the vast majority of modem/ISDN devices. The code is sent when
the AdderView CATx IP is first switched on or whenever the Initialize button is
clicked.
Initialize Port
When selected, this option sends the characters entered in the ‘Init string’ field
to the connected modem or ISDN terminal adapter.
Restore Defaults
When selected, this option resets the ‘Baud rate’ and ‘Init string’ values to their
original default settings.
AdderView CATx IP Modem Config
ATZS0=1
192.168.3.2
192.168.3.1
115200
Initialize Port
Restore Defaults
CancelSave
Init String
Baud Rate
Client IP
Server IP
To get here
1 From a local or remote (not accessible from a global keyboard), log on as
the ‘admin’ user.
2 Press
(hotkeys can change).
3 Press to select ‘More menus’.
4 Select ‘Functions’.
5 Select ‘Configure IP port’.
6 Select ‘Modem Configuration’.