Filter
Top Products
Features in 276-04 15
Version 276-05
C613-10474-00 REV D
CR00012846
ASYN, Log 2 The following issues occurred with sending log messages to an asynchronous
port:
■ The log messages output on an asynchronous port were corrupt.
■ When log messages were output to an asynchronous port, that port was
(correctly) locked. However, the port remained locked after the asynchronous
log output definition was destroyed, and after the log output's destination
was changed from asynchronous to something else.
■ It was possible for a user to change the log output destination to an
asynchronous port while the user was logged into the asynchronous port. This
resulted in the user losing access to the command line interface.
■ It was possible to create a log output definition with an asynchronous port as
the destination even when another user was logged into that asynchronous
port. This resulted in the other user losing access to the command line
interface.
■ If a user changed the log output destination to an asynchronous port and
specified invalid parameters in the command, an error message was displayed
but the new output destination was saved anyway.
■ The set command allowed a user to specify an asynchronous port as the
destination without specifying the asynchronous port number. The number
defaulted to asyn0, which may not have been the desired port.
These issues have been resolved.
Y - YYYYY- - -
CR00012868
ENCO 2 Entering the command create enco key=number ip=? caused the router or
switch to reboot.
This issue has been resolved.
Y - YYYYY- - -
CR00012951
IPv6 2 RIPng (for IPv6) sometimes sent sub-optimal routes to its neighbours. When
RIPng was configured in a network with loop topology, this could cause unstable
routing table entries on the neighbours (the metric kept being updated, as a
result of updates from neighbours).
This issue has been resolved. RIPng no longer sends sub-optimal routes.
Y -YYY--- - -
CR Module Level Description
AR44xS/ AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800