Filter
Top Products
Configuring Basic Parameters
Commissioning
71
Table 3-1: Basic Parameters
Parameter Default Value Comment
User Defined Frequency Subsets
(SU)
All frequencies
Transmit Power Dependent on HW
revision, unit type and
Sub-Band
Transmit Power in SU
cannot be higher than
the Maximum Tx Power
parameter.
Maximum Tx Power (SU)
Dependent on HW
revision and Sub-Band
Maximum Tx Power
cannot be higher than
the upper limit
according to the Sub-
Band in use.
Tx Power (AU) On
Antenna Gain (units with external
antenna)
According to the antenna
supplied with the unit and
the Sub-Band.
If set to “Not Set Yet”,
must be configured
according to actual
value, taking into
account cable’s
attenuation.
ATPC Option Enable
Best AU Support (SU) Disable
Preferred AU MAC Address (SU) 00-00-00-00-00-00
(none)
Applicable only when
Best AU Support is
enabled.
Cell Distance Mode (AU) Automatic
Maximum Cell Distance (AU) 0 (No Compensation)
Fairness Factor (AU) 100 (%)
Per SU Distance Learning (AU) Disable
Maximum Modulation Level (SU) 8 (or the highest value
supported according to
the country code). Not
higher than 7 for units
with HW revision A.
Refer to section 3.4.
Wi2 IP Address (SU) 0.0.0.0 (none)