Filter
Top Products
Parameters Summary
BreezeACCESS VL System Manual
229
Parameter Unit Range Default Run-Time
Spectrum Analysis
Channel Scan Period
AU, SU 2 – 30 seconds 5 seconds Yes
(Configured
per
analysis)
Spectrum Analysis Scan
Cycles
AU, SU 1 – 100 cycles 2 cycles Yes
(Configured
per
analysis)
Automatic Channel
Selection
AU Disable
Enable
Disable Yes
Lost Beacons Watchdog
Threshold
AU 100 – 1000, 0 means Not
Used
218 Yes
Noise Immunity State
Control
AU, SU Automatic
Manual
Automatic Yes
Noise Immunity Level AU, SU 0 – 4
Use only 0 or 4
0 Yes
Spur Immunity Level AU, SU 0 – 7 0 Yes
OFDM Weak Signal AU, SU 0 (not active) or 1 (active) 0 Yes
Pulse Detection
Sensitivity
AU, SU Low
High
Low Yes
Noise Floor Calculation
Mode
AU, SU Fully Automatic
Forced
Automatic with Minimum
Value
Fully Automatic Yes
Noise Floor Forced Value AU, SU -107 to -55 (dBm) 5 MHz bandwidth: -102
10 MHz bandwidth: -99
20 MHz bandwidth: -96
Yes
* Not applicable if only one Sub-Band is available for the applicable Country Code
** Applicable only if DFS is supported by the Sub-Band
*** Configurable only in units without an integral antenna.