Filter
Top Products
Chapter 2 - Installation
BreezeACCESS VL System Manual
50
2.3.5.2 Units with a Waterproof Seal Supplied with the Ethernet
Cable (not applicable to new ODU)
To connect the indoor-to-outdoor cable:
1 Verify that the o-ring supplied with the cable kit is in place.
2 Connect the RJ-45 connector of the Ethernet cable to the outdoor unit.
3 Attach the waterproof seal to the unit. Tighten the top nut.
4 Route the cable to the location selected for the indoor equipment.
5 Assemble an RJ-45 connector with a protective cover on the indoor end of the
indoor-to-outdoor cable.
See Appendix D for instructions on preparing the cable.
2.3.5.3 New ODU
1 The sealing cap has a special groove allowing to insert an ethernet cable with
an already assembled RJ-45 connector through the cap. To expose the groove,
lightly squeeze the cap. Carefully insert the cable with the assembled
connector through the groove.
Figure 2-11: Inserting the IDU COM Cable into the Sealing Cap
2 Connect the Ethernet cable to the IDU COM RJ-45 connector.
3 Put the sealing cap back in its place. Make sure that the small protrusion on
the side of the cap fits inside the hole on the connector's protective body.
Figure 2-12: Connecting the IDU COM connector and inserting the Sealing Cap
4 Route the cable to the location selected for the indoor equipment.