Filter
Top Products
Chapter 3 - Commissioning
BreezeACCESS VL System Manual
74
1. When operating at 4945 MHz, the Transmit Power parameter in the AU
should not be set to a value above 11 dBm. The Maximum Transmit Power of
the SU should not be set to a value above 10 dBm.
2. When operating at 5055 MHz, the Transmit Power parameter in the AU
should not be set to a value above 13 dBm. The Maximum Transmit power of
the SU should not be set to a value above 10 dBm.
This requirement, although not indicated in the certification document, is needed
following the tests performed in the certification lab.
NOTE 2 (FCC 5.3 GHZ, 10 MHz Bandwidth)
For full compliance with FCC regulation of units with HW rev C using a 10 MHz
bandwidth, if you wish to include frequency channel 5265 MHz in the set of
frequencies to be used, then the Transmit Power parameter in the AU, and the
Maximum Tx Power parameter in the SUs, should not be set to a value above “25-
Antenna Gain”. If there is a need to use a higher value for these parameters, this
frequency should not be used.
NOTE 3 (FCC 5.3 GHZ, 20 MHz Bandwidth)
For full compliance with FCC regulations, the following requirements should be
followed in units using a 20 MHz bandwidth:
1. In units HW Revision B, if you wish to include frequency channel 5270 MHz
in the set of frequencies to be used, then the Transmit Power parameter in
the AU, and the Maximum Tx Power parameter in the SUs, should not be set
to a value above “17-Antenna Gain”. If there is a need to use a higher value
for these parameters, this frequency should not be used.
2. In units with HW Revision C, if you wish to include one or more of frequency
channels 5270, 5275 and 5330 MHz in the set of frequencies to be used,
then the Transmit Power parameter in the AU, and the Maximum Tx Power
parameter in the SUs, should not be set to a value above “20-Antenna Gain”.
If there is a need to use a higher value for these parameters, this frequency
should not be used.