Filter
Top Products
Chapter 4 - Operation and Administration
BreezeACCESS VL System Manual
102
Table 4-3: Parameters that are not changed after Set Partial Factory/Operator
Defaults
Parameters Group Parameter
Network Management Parameters Wi2 IP Address (SU)
Performance Parameters Adaptive Modulation Decision Thresholds
Bridge Parameters VLAN ID – Management
Service Provider VLAN ID (SU)
VLAN QinQ Protocol Ethertype
MAC Address List (AU)
MAC Address List Action (AU)
Service Parameters DRAP Option (AU)
UDP Port (AU)
Max Number of Voice Calls (AU)
DRAP TTL (AU)
Wireless Link Prioritization Option (AU)
Low Priority AIFS (AU)
Number of HW Retries for High Priority Traffic (AU)
Number of HW Retries for Low Priority Traffic (AU)
AU Burst Duration for High Priority Traffic (AU)
AU Burst Duration for Low Priority Traffic (AU)
SU Burst Duration for High Priority Traffic (AU)
SU Burst Duration for Low Priority Traffic (AU)
Low Priority Traffic Minimum Percent
Country Code Parameters Selected Country Code
4.2.3.2.1.3 Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding several parameters that are listed in Table 4-2.