Filter
Top Products
Chapter 2 - Installation
BreezeACCESS VL System Manual
58
NOTE
Ensure that the antenna is mounted vertical to the floor, with the connector facing downward, and
the front of the antenna facing to the exterior of the building, preferably directed towards the Base
Station.
CAUTION
In order to avoid damage from lightning strikes, the antenna must be placed below roof level.
2.5.5.1 Wall Mount
The installation kit includes 2 plastic anchors and 2 #8 screws.
1 If anchors are needed (wall-board, plaster board, etc.), drill two holes for the
anchors using a 5 mm drill bit and insert anchors. Use a 9/64" drill bit for
screwing directly into a solid surface (stud).
2 Fasten the antenna to the wall. Refer to Figure 2-15 for directions. Use the
two #8 screws provided with the kit. Do not over tighten.
3 Connect the antenna cable to the connector located on the bottom side of the
antenna. Hand tighten, do not use a wrench or a similar tightening tool. Do
not over tighten.