Filter
Top Products
Preface
007-5510-002 ix
Warning Operation of the Enclosure with ANY modules missing will disrupt the airflow and the drives will
not receive sufficient cooling. It is ESSENTIAL that all apertures are filled before operating the
unit.
• Drive Carrier Module Caution Label: Drive spin down time 30 seconds
Recycling of Waste Electrical and Electronic
Equipment (WEEE)
At the end of the product’s life, all scrap/ waste electrical and electronic equipment should be recycled
in accordance with National regulations applicable to the handling of hazardous/ toxic electrical and
electronic waste materials.
Please contact your supplier for a copy of the Recycling Procedures applicable to your product.
Important Observe all applicable safety precautions, e.g. weight restrictions, handling batteries and lasers
etc., detailed in the preceding paragraphs when dismantling and disposing of this equipment
Rack System Precautions
Important SGI InfiniteStorage 15000 drive enclosures should only be installed in SGI InfiniteStorage 15000
racks. Mounting and installing these drive enclosures in any other rack is not authorized or
supported by SGI.
The SGI InfiniteStorage 15000 drive enclosures are pre-installed in the rack before shipment. If the drive
enclosures must be re-installed and mounted, the following safety requirements must be considered
when the unit is mounted in a rack.
• The rack stabilizing (anti-tip) plates should be installed and secured to prevent the rack from tipping
or being pushed over during installation or normal use.
• When loading a rack with the units, fill the rack from the bottom up and empty from the top down.
• Always remove all modules and drives, to minimize weight, before loading the chassis into a rack.
Warning It is recommended that you do not slide more than one enclosure out of the rack at a time, to avoid
danger of the rack tipping over.
• When mounting in a rack, ensure that the enclosure is pushed fully back into the rack.