Filter
Top Products
Controller Management
007-5510-002 77
Figure 3–54 Telnet Statistics
The administrator is strongly advised to perform any commands affecting the system’s configuration
from the CLI UART only (and not from a Telnet session), and to only perform such commands after
issuing the TELNET DISABLE command, so that remote users cannot log into the system in the middle
of an administrative command.
3.6.1 When a Telnet Session is Active
Whenever a remote Telnet session is active, the current RS-232 console switches to a CLI sub-shell
which allows the administrator to enter a very limited sub-set of the CLI commands. The following
message is displayed on the console when a Telnet session is initiated from a remote site (Figure 3–55).
Figure 3–55 Telnet Session Initiated
15000 [1]:
New TELNET Session initiated from IP address: 010:123:139:005
[Remote TELNET session ON] Local SUBshell 15000 [1]: