Filter
Top Products
Controller Installation
007-5510-002 23
After you have initiated LUN format, the message Starting Format of LUN is displayed.
You can monitor the format progress by entering the command
LUN (see Figure 2–9).
Upon completion, this message: Finished Format of LUN 0 displays.
Figure 2–9 Logical Unit Status - Formatting
7. Enter the command LUN to check the status of the LUN, which should be “Ready” (see Figure 2–
10
).
Figure 2–10 LUN Status - Ready
8. To create the LUN 1, type:
lun add=1
<Enter>
9. Enter these parameters:
- Enter a label for the LUN 1
- For capacity, enter the value in MBytes:
8192
<Enter>
- Enter the number of tiers to use:
2
<Enter>
- Select the tier(s) by entering the Tier number. Enter each one on a new line and press the
<Enter>
key. The tiers are numbered from 1 through 125.
1
<Enter>
2
<Enter>
- Enter the block size in Bytes: 512
<Enter>
- When asked to format the LUN, type:
y
<Enter>
NOTE :
LUN format is a background process and you can start adding the next LUN as soon as the
format for the previous LUN has started.
Logical Unit Status
Block
Size
LUN Owner Tier ListCapacity
(Mbytes)
512
------------------------------------------------------------------------------
8192Format 14%0
System Capacity 2240096 Mbytes, 2207328 Mbytes available.
Status
1 1 2 3 4 5 6 7 8
15000 [1]: lun
Tiers
8
Label
Logical Unit Status
Block
Size
LUN Owner Tier ListCapacity
(Mbytes)
512
------------------------------------------------------------------------------
8192Ready0
System Capacity 2240096 Mbytes, 2207328 Mbytes available.
Status
1 1 2 3 4 5 6 7 8
15000 [1]: lun
Tiers
8
Label