Filter
Top Products
Controller Management
007-5510-002 33
The PORT=X|ALL parameter specifies the specific host port(s) (1 to 4) to be affected when used in
combination with any of the other parameters: ID, TIMEOUT, SPEED (for FC only), or WWN. The
default is to apply changes to ALL host ports.
Figure 3–5 FC Host Ports Configuration Screen
Figure 3–6 IB Host Ports Configuration Screen
3.2.1.1 Host ID
HOST ID=<new ID> changes the hard loop ID of a host port. The system selects a soft ID if the hard
loop ID is already taken by another device. This parameter is entered as an 8-bit hex value. The default
value is EF.
Host WWN
HOST WWN=X|DEFAULT overrides the system ID and specifies a different World Wide Name (WWN)
for a host port. This parameter is entered as an 64-bit hex value. Default WWN is based on the serial
number of the unit.
3.2.1.2 Host Status
HOST STATUS displays the loop status of each host port (Figure 3–7).