Filter
Top Products
Notices
FCC Statement
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to
correct the interference at his own expense.
» Note:
To comply with part 15 of FCC rules, shielded interface cables
must be used.
Canadian Users Notice
This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus set out in the Radio Interfer-
ence Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques (de la
classe A) prescrites dans le Règlement sur le brouillage radioélec-
trique édicté par le ministère des Communications du Canada.
WARNING!
To prevent electrical shock, do not remove any covers
from your printer unless you are experienced in working with circuit
boards and are following instructions for procedures described in
QMS documentation.
ACHTUNG!
Um einen Elektroschock zu vermeiden, sollte die
Druckerabdeckung niemals von Unbefugten geöffnet werden. In
jedem Fall müssen die diesbezüglichen Hinweise des Handbuches
genau beachtet werden!