Filter
Top Products
Download Location
Controls the default storage location of PCL objects (fonts,
macros, and patterns).
Menu
Administration
Emulations
HP PCL 5C
Downld Location
Choices
Disk (default)—All downloaded PCL objects are
stored in the default disk resource, if present.
These objects remain on the disk even if the
printer power is turned off. (If this option is set to
Disk and no hard disk is installed, RAM is used
as the default storage location.)
Memory—All downloaded PCL objects are stored
in temporary storage in RAM. If the printer has
both a hard disk and a large amount of memory,
setting this option to Memory enhances printer
performance.
Notes: Document Option Commands specifying resources override this
option on a per-job basis (unless the location is specified as RAM, in
which case DOC does not override).
Before you download any objects, ensure that the printer has enough
memory, or they may not be available for use. If it doesn’t, you can install
additional SIMMs to increase printer memory, or, if a hard disk is available,
you can enable disk swapping (Administration/Memory/Enable Disk Swap
menu).