Filter
Top Products
Miscellaneous
Manual Feed Timeout
This option allows you to set the amount of time the printer waits
for paper to be inserted into the manual feed slot before it cancels
the job.
Menu
Administration
Engine
Man. Feed Timeout
Choices
000 - 300 seconds
060 seconds (default)
Notes: A value of 000 sets the timeout to infinity
Restore Defaults
If you need to cancel all of the configuration changes you have
made, you can reset all of the configuration settings to their factory
defaults
Menu
Administration
Miscellaneous
Restore Defaults
Choices
Yes, No (default)
Notes: This process takes several minutes to complete. Remember that
any changes made to the configuration menu are lost when the factory
defaults are restored, so if you think any changes have been made, it’s a
good idea to print an advanced status page (Administration\Special
Pages\Print Status menu) to have a record of these changes. If the printer
has a hard disk and you have enabled disk swapping (recommended to
take advantage of a hard disk), you should re-enable it after restoring
factory defaults (Administration\Memory\Enable Disk Swap menu).
Reboot System
You can use this selection to restart the printer without turning off
the power switch. You would use this when you’ve made changes
to the configuration and need to restart the printer before the new
settings will be acknowledged.
Menu
Administration
Miscellaneous
Reboot System
Choices
Yes, No (default)