Filter
Top Products
Chapter 5 Router Connection Setup RX3141 User’s Manual
32
5.2.3.1 WAN PPPoE Unnumbered Configuration Parameters
Table 5.3 describes the configuration parameters available for PPPoE unnumbered connection mode.
Table 5.3. WAN PPPoE Unnumbered Configuration Parameters
Setting Description
Connection Mode
Select
PPPoE Unnumbered
from the connection mode drop-down list.
Traditionally, each network interface must have a unique IP address.
However, an unnumbered interface does not have to have a unique IP
address. This means that when this option is selected, the WAN and the LAN
use the same IP address. Network resources are therefore conserved
because fewer network IP addresses are used and routing table is smaller.
Enable NAPT
Check or uncheck this box to enable NAPT for this connection.
Connect on Demand
Check “
Enable
” or “
Disable
” radio button to enable/disable this option.
Disconnect after Idle
(min)
Enter the inactivity timeout period at which you want to disconnect the Internet
connection when there is no traffic. A value of 0 means no activity time out.
Note that SNTP service may interfere with this function if there are activities
from the service.
IP Address
Enter a static IP address here for the PPPoE unnumbered connection. This
IP address must be provided by your service provider.
Unnumbered network
address
Enter the network address provided by your ISP.
Unnumbered netmask
Enter the subnet mask provided by your ISP.
User Name and
Password
Enter the username and password you use to log into your ISP. (Note: this is
different from the information you used to log into Configuration Manager.)
Service Name
Enter the service name provided by your ISP. Service name is optional but
may be required by some ISPs.
Status
On: PPPoE unnumbered connection is active.
Off: No PPPoE unnumbered connection is inactive.
Connecting: RX3141 is trying to connect to your ISP using PPPoE
unnumbered connection mode.
Manual
Disconnect/Connect
Click the
Disconnect
or
Connect
button to disconnect or connect to your
service provider using the PPPoE unnumbered connection mode.