Filter
Top Products
Chapter 9. Configuring Firewall/NAT Settings RX3141 User’s Manual
56
Figure 9.3 illustrates how to create a rule to allow inbound HTTP (i.e. web server) service. This rule allows
inbound HTTP traffic to be directed to the host w/ IP address 192.168.1.28. Note that the newly added inbound
ACL rule is displayed in the Existing Inbound ACL table shown in Figure 9.4.
Figure 9.3. Inbound ACL Configuration Example
9.4.2 Figure 9.4. Sample Inbound ACL List TableModify Inbound ACL Rules
To modify an inbound ACL rule, follow the instructions below:
1. Open the Inbound ACL Rule configuration page, as shown in Figure 9.2, by double clicking the
Router Setup
Î
Inbound ACL
menu.
2. Click on the
icon of the rule to be modified in the inbound ACL table or select the rule number
from the “
ID
” drop-down list.
3. Make desired changes to any or all of the following fields: action, source/destination IP,
source/destination port, protocol, ICMP message type and log. Please see Table 9.3 for
explanation of these fields.
4. Click on the
button to modify this ACL rule. The new settings for this ACL rule will
then be displayed in the inbound access control list table at the bottom half of the Inbound ACL
Configuration page.
9.4.3 Delete Inbound ACL Rules
To delete an inbound ACL rule, open the Inbound ACL Rule configuration page by double clicking the
Router
Setup
Î
Inbound ACL
menu and then click on the in front of the rule to be deleted.