Filter
Top Products
Chapter 5 Router Connection Setup RX3141 User’s Manual
34
5.2.5 Static IP
Figure 5.13. WAN – Static IP Configuration
5.2.5.1 WAN Static IP Configuration Parameters
Table 5.4 describes the configuration parameters available for static IP connection mode.
Table 5.4. WAN Static IP Configuration Parameters
Setting Description
Connection Mode
Select
Static
from the connection mode drop-down list.
IP Address
WAN IP address provided by your ISP.
Subnet Mask
WAN subnet mask provided by your ISP. Typically, it is set as 255.255.255.0.
Gateway Address
Gateway IP address provided by your ISP. It must be in the same subnet as
the WAN on the RX3141.
Primary/Secondary
DNS Server
You must at least enter the IP address of the primary DNS server. Secondary
DNS server is optional
5.2.5.2 Configuring Static IP for WAN
Follow the instructions below to configure static IP settings:
1. Open the Router Connection configuration page by double clicking the
Router Setup
Î
Connection
menu.
2. Select Static from the Connection Mode drop-down list as shown in Figure 5.13.
3. Enter WAN IP address in the IP Address field. This information should be provided by your ISP.
4. Enter Subnet Mask for the WAN. This information should be provided by your ISP. Typically, it is
255.255.255.0.
5. Enter gateway address provided by your ISP in the space provided.
6. Enter the IP address of the primary DNS server. This information should be provided by your ISP.
Secondary DNS server is optional.
7. Click
to save the settings
.
Connection
Mode drop-
down list