Filter
Top Products
CN8000 User Manual
60
When you have finished making your settings on this page, click Apply.
Dial Out Schedule This entry sets up the times you want the CN8000 to dial out over
the ISP connection.
Every provides a listing of fixed times from every hour to every
four hours.
If you select Every two hours (for example), the CN8000 will
start dialing out every two hours beginning at the next
complete hour (if it is now 13:10, it will start dialling at 14:00).
If you don't want the CN8000 to dial out on a fixed schedule,
select Never from the list.
Daily at will dial out once a day at a specified time. Use the
hh:mm format to specify the time.
PPP online time specifies how long you want the ISP connection
to last before terminating the session and hanging up the
modem. A setting of zero means it is always on line.
Emergency Dial
Out
If the CN8000 gets disconnected from the network, or the network
goes down, this function puts the CN8000 on line via the ISP dial up
connection.
If you choose PPP stays online until network recovery, the PPP
connection to the ISP will last until the network comes back up or
the CN8000 reconnects to it.
If you choose PPP online time the connection to the ISP will
terminate after the amount of time that you specify is up. A
setting of zero means it is always on line.
Dial Out Mail
Configuration
This section provides email notification of the CN8000’s IP address
once its been obtained from the ISP.
Note: This email notification differs from the one configured under
SMTP Settings, page 41, in that it uses the ISP mail server rather
than the internal company’s mail server.
Key in the IP address or domain name of your SMTP server in
the SMTP Server IP Address field.
Key in the email address of the person responsible for the SMTP
server (or some other equally responsible administrator), in the
Email From field.
Key in the email address (addresses) of where you want the
report sent to in the To field. If you are sending the report to more
than one email address, separate the addresses with a comma
or a semicolon.
If your server requires authentication, put a check in the My
server requires authentication checkbox, then key in the
appropriate account name and password in the fields, below.
Item Action