Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 97
The syntax for this command is:
set outband negotiation {enable | disable}
Example:
set outband speed
User level: read-write, admin.
Use the set outband speed command to configure the speed of Ethernet
Console port.
In auto negotiation mode, the port's speed is determined by auto negotiation. If you
attempt to set the speed when auto negotiation is enabled, the following message is
displayed “Auto negotiation is Enable, can not set the speed
mode.”
The syntax for this command is:
set outband speed <speed>
Example:
set policy type
User level: read-write, admin.
Use the set policy type command to set whether the C460 switch enforces the
active policy-list on all packets or only on routed packets (in “device-mode router”).
enable Enable link negotiation protocol.
disable Disable link negotiation protocol.
C460-1# set outband negotiation enable
Auto-negotiation for outband port set successfully
speed • 10MB
• 100MB
C460-1# set outband speed 100MB
Speed for outband port set successfully