Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
114 Avaya C460 Reference Guide
Example:
To enable PoE on ports 1 to 3 of module three to High:
set port redundancy
User level: read-write, admin.
Use the set port redundancy command to globally enables or disable the
redundancy pairs you have defined. Using this command will not delete existing
redundancy entries.
L Disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
priority The priority level for powering the port:
•Critical
•High
•Low
C460-1# set port powerinline 3/1-3 high
Load detection process on ports 3/1-3 was set to High
C460-1# set port redundancy enable
All redundancy schemes are now enabled