Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 79
To enable the RIP protocol:
router vrrp
User level: read-write, admin.
L If you are at the “read-write” user level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the command to enable VRRP routing globally.
Use the no router vrrp command to disable VRRP routing.
The syntax for this command is:
[no] router vrrp
Example:
session
User level: read-only, read-write, admin.
Displays existing sessions or to opens a session with a specific Supervisor Module in
the chassis.
The syntax for this command is:
session [[module_number>] {switch | router}]
C460-1(configure)# router rip
Done!
C460-1(configure)# router vrrp
Done!
module The Supervisor module number (1 to 2).
switch|router
(Optional)
• The entity to which you want to open a
session.
• If you do not specify this parameter, you
will get the default entity of the specific
module:
• switch - Layer 2 entity of the module.
• router - Routing entity