Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 99
set port auto-negotiation-flowcontrol-advertisement
User level: read-write, admin.
Use the set port auto-negotiation-flowcontrol-advertisement
command to set the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <module>/
<port> [mode]
Example:
set port channel
User level: read-write, admin.
Enables or disables a Link Aggregation Group (LAG) interface on the switch. LAG
creation requires a LAG name to be specified. There is no default name.
You can also add or remove a port from an existing LAG. All ports in the LAG are
configured with the parameters of the first port that is added to the LAG. These
parameters include port administrative status, speed, duplex, autonegotiation
mode, VLAN ID, tagging mode, binding mode, and priority level. When adding a
port to an existing LAG, the user must type the same LAG-name (or no LAG-name),
module Number of the module (3-6).
port Number of the port on the module. If you do not specify a
number, all the ports on the module are set.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on module 4.
mode • no-flowcontrol – the port will advertise no pause
capabilities.
• asym-tx-only – the port will advertise asymmetric Tx
pause capabilities only.
• sym-only – the port will advertise symmetric pause
capabilities only.
•sym-and-asym-rx – the port will advertise both
symmetric and asymmetric Rx pause capabilities.
C460-1# set port auto-negotiation-flowcontrol-advertisement
2/5 asym-tx-only
Port 2/5 pause capabilities was set