Chapter 2 Avaya C460 CLI Commands
116 Avaya C460 Reference Guide
The syntax for this command is:
set port redundancy-intervals <min-time-between-switchovers>
<switchback-interval> | none
Example:
set port spantree
User level: read-write, admin.
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree {enable|disable} [module/port]
Example:
min-time-between-switchovers The minimum time between redundancy
switchovers for each pair (in milliseconds).
switchback-interval The period the primary port link has to be
“up” before the system switches back (in
milliseconds).
• If switchback interval is zero, the system
never switches back
• If it is one, switchback occurs immediately
after the primary port link returns
none The system switches bank only if the
secondary link fails.
C460-1# set port redundancy-intervals 100 20
Done!
enable|disable Enables or disables the spanning tree mode for the
specified ports.
Module Module number
Port Port number
C460-1# set port spantree enable 3/1
port 3/1 was enabled on spantree
